I have the same question. I would like to use the MC6 to change my snapshots to free up switches for stomps on the helix. The only indication of which snapshot i am on is on the helix screen with the little number in the top right. It would be helpful to blink or change the name on the mc6 so it indicates which snapshot button i pushed last.
I answered my own question will a little research and exploration.
I set each of the buttons to toggle mode and blinking on.
Then on release of each button, I use set toggle to clear all the other buttons' toggle states.
To test, you have to get out of edit mode.
Morningstar really thought of a lot of scenarios.
Finding the answer was harder than I would expect. I can't seem to find the manual for the MkII that discusses all this stuff. The manual I found was very thin and the MkI manual didn't cover it.
I have the same question. I would like to use the MC6 to change my snapshots to free up switches for stomps on the helix. The only indication of which snapshot i am on is on the helix screen with the little number in the top right. It would be helpful to blink or change the name on the mc6 so it indicates which snapshot button i pushed last.
I answered my own question will a little research and exploration.
I set each of the buttons to toggle mode and blinking on.
Then on release of each button, I use set toggle to clear all the other buttons' toggle states.
To test, you have to get out of edit mode.
Morningstar really thought of a lot of scenarios.
Finding the answer was harder than I would expect. I can't seem to find the manual for the MkII that discusses all this stuff. The manual I found was very thin and the MkI manual didn't cover it.