Hello. From my reading I believe this will work, but I've made mistakes before, many actually, so I thought I'd ask for opinions.
I would like to connect as follows - MIDI out of the MC6 to the MIDI in of the BeatBuddy, then out to a splitter which goes to the MIDI in of the Infinity looper and the MIDI in of the Y-NOT switch pedal (rjmmusic.com). The BeatBuddy will control the MIDI clock of the Infinity, and the MC6 will control the BeatBuddy, Infinity, and the Y-NOT. The CC numbers that each unit uses for its own control are unique between these units. I'm thinking set up like this, I can program a single button to simultaneously send CC messages to each of these units. Is that correct?
Another routing I'm considering is to hook up the MIDI in of all of the units to the MIDI out of the MC6, using a splitter, and then the MIDI out of the BeatBuddy to the MIDI in of the MC6. Would that enable me to pass the MIDI clock sync from the BeatBuddy to the Infinity, and also enable MC6 control of all three units, or would it create an infinite loop of MIDI commands? I think the BeatBuddy can be set to not forward any MIDI information it receives.
Thanks much for any thoughts.
One more question, what is the width and length dimension of the MC6?