I assigned one of the footswitches to bank up when you press it, and to bank down when you hold it. This is working great, and I love this functionality to consolidate tasks into one switch.
However, when scrolling to the bank down, the difference in milliseconds between scrolling down one bank and scrolling down two + banks is very minimal. That is, when I hold the switch, I have to time it very carefully so that it only goes down one bank.
I was wondering if there is a way around this? I tried adding an additional conditional message at the end to "do nothing" hoping that it would end the sequence of messages after one bank down. However the bank down message doesn't end until I let go of the footswitch. So this plan didn't work.
Maybe I can change the switch sensitivity?
Any suggestions, or is this just how it is?