I was under the impression that after I assigned MC6 buttons to enable / disable blocks in the Stomp that when changing presets in the Stomp, would send a message to the MC 6 to tell it if those blocks were enabled or disabled.
My problem: a.) Preset 1 has delay enabled, MC 6 says Delay ON
I use the Stomp to select the next preset 2 where I want the delay off, which it is
b.) Switch to preset 2, delay is off, which I want, but MC6 still says Delay ON.
I have to double press the button on the MC6 from Delay ON, toggle it to Off, then I can turn it on.
Is there a way to fix this so that when I change presets, the MC6 is aware of what's on and what is not, especially seeing how those blocks (on or off) are assigned to the MC6?