Get in touch

  • Instagram - White Circle
  • Facebook - White Circle
  • YouTube - White Circle

© 2019 Morningstar FX Pte Ltd

Nov 24, 2017

MC6 Bank Up/Down

1 comment

Hey guys. I'm new to the MC6 world and I'm loving every minute of it

 

I've built myself a little 2 button extension switch to bank up and down on the MC6. I've noticed that there is a scarily fine line between banking up one bank and scrolling through more than one bank. Is there any way to set this up so that it's harder to go further than 1 bank? Like can you make it so that you have to hold the switch for longer or even reduce those 2 switches sensitivity?

 

Secondly I noticed that when i hit one of the switches and then hit the other one while the MC6 is still displaying the bank then the second switch will continue scrolling in the direction that the first one was? For example if I hit the bank down switch and quickly then start pressing the bank up switch it will continue to bank down until the display clears. Is this something I have done wrong with my switch or is this normal for the MC6?

 

Thanks so much for your advice

Nov 27, 2017

I've had the same issue with it scrolling through multiple banks when I just intend to scroll through one. I tried changing the switch sensitivity but I don't recall that helping.

 

What I did, though, was use the Set Bank MIDI type. It's a little more tedious, but should do what you want. Here's how I use it:

 

- When on bank 1, assign a switch to Set Bank and choose bank 2. When you step on the switch, it will take you to bank 2 and then stop.

- When on bank 2, assign the same switch to Set Bank and choose bank 3. Pressing the switch will then take you to bank 3 and stop.

- Etc.

 

I have designated 7 banks for my 7 midi devices, used as sort of a main page for each device. I want to be able to scroll from one device to the next. So for these 7 banks, I use the Set Bank message. I also set a conditional message, so when the switch is pressed, it goes to the next bank. When the switch is held, it goes to the previous bank. For all other banks outside of these 7 device "home pages", I use the MC6 Bank Up/MC6 Bank Down messages.

New Posts
  • I'm not sure what I'm missing here. I set preset D as follows: action: press type: pc scroll up slot: 1 lower limit: 0 upper limit: 10 midi channel: 1 increment: yes Looking at the midi monitor, every time I press the D switch, it sends PC 0. It seems like increment isn't working. What am I missing here?
  • Hi, Im using an MC6 linked to an Elektron Analog Heat Mk2 Running 3.4.1 and 3.4.2beta do the same Using an EV 30 dual expression pedal. I've set the bank so that the expression pedal controls 2 CC messages. #12 for Drive and #74 for filter frequencey What I'm trying to do is set footswitch A to toggle the message to control Filter on/off, and footswitch D to do the same for drive However, after saving it and trying out the pedal. The first message will be triggered after pressing Preset A (filter) , but Pressing press B (wont control drive) Also, after saving preset A with msg1. when I press the button for preset B, save it with msg 2, then press the button for preset A again, msg 2 is written for preset 1. Sometime the Toggle Prosition is also changed from Expression 1 to 2. Help...I've followed the blog post and im doing everything correct so why is this happening.
  • Installed the new firmware cant get midi monitor to work. Im new to all this so be nice. I downloaded and installed the new editor. I see there are 2 source files below the main download. do I need to do something with those?