Hi, Im using an MC6 linked to an Elektron Analog Heat Mk2 Running 3.4.1 and 3.4.2beta do the same Using an EV 30 dual expression pedal. I've set the bank so that the expression pedal controls 2 CC messages. #12 for Drive and #74 for filter frequencey What I'm trying to do is set footswitch A to toggle the message to control Filter on/off, and footswitch D to do the same for drive However, after saving it and trying out the pedal. The first message will be triggered after pressing Preset A (filter) , but Pressing press B (wont control drive) Also, after saving preset A with msg1. when I press the button for preset B, save it with msg 2, then press the button for preset A again, msg 2 is written for preset 1. Sometime the Toggle Prosition is also changed from Expression 1 to 2. Help...I've followed the blog post and im doing everything correct so why is this happening.
Installed the new firmware cant get midi monitor to work. Im new to all this so be nice. I downloaded and installed the new editor. I see there are 2 source files below the main download. do I need to do something with those?
Hi Morningstar ! My 1st post here. I have just ordered a MC6 MK II and I will need to attach a 3 Button Auxiliary Pedal with it. My local music store has one of these Digitech FS3X 3 Button Pedals in store ... my question is:- => will the Digitech FS3X 3 Button Pedal work as an external 3 button auxiliary swtich with the MC6 MK II (?) => if so, do I need to do anything special / different for the MC6 MK II to correclty recognise and use it (?) Thanks, Ben